GnarlyFPV Primo V110X Frame

5 2
$17.00

Included:
Primo 110X Frame
1x Set 65mm props (1mm hole)
Jelly mount
Canopy
1S EZ swap battery mount
1S side by side EZ Swap battery mount
2S EZ swap battery mount
Hardware

Supports the below models electronics (just add your favorite 110X motor):
Eachine Trashcan
Mobula7
Beta65 pro
Beta65 Pro 2
Beta65 X
Beta75 Pro
Beta75 Pro 2
UK65
US65
Snapper 6
Snapper 7

OR
  • DESCRIPTION
  • REVIEWS
  • THE PRIMO 110X VERSION!

     Designed to take the current 1S and 2S Brushless whoops guts, planting them into a frame that pushes the limits of micro fpv! I designed the Primo's to make the swap as simple and seamless as possible. I wanted something that could be swapped over in a matter of minutes, with no soldering required. The battery mounts are quick swap, using 1 m2 screw. Allowing you the ability to swap from 1s to 2s batteries is seconds. Frames are stout, at 2mm's thick However, as tough as the Primo is, its not indestructible, so replacement frames will be available separately. Each kit will include all hardware needed for a brushless whoop swap. Just add your 1-2s whoop guts. Supports 16X16 stacks with optional canopy and stack mounts. Available in 080X and 110X flavors. 

    This 110X version does support both 9mm and 8.5mm mounting patterns.

     

    Included:

    • Primo 110X Frame
    • 1x Set 65mm props (1mm hole)
    • Jelly mount 
    • Canopy
    • 1S EZ swap battery mount 
    • 1S side by side EZ Swap battery mount
    • 2S EZ swap battery mount
    • Hardware

    Supports the below models electronics (just add your favorite 110X motor):

    • Eachine Trashcan
    • Mobula7
    • Beta65 pro
    • Beta65 Pro 2
    • Beta65 X
    • Beta75 Pro
    • Beta75 Pro 2
    • UK65
    • US65
    • Snapper 6
    • Snapper 7

     

    UPDATES:

    • The Primo Canopy has been updated and will now support the EOS2 Camera, along with the Eachine trashcan VTX while also supporting the Mobula7 AIO Camera. Alternative AIO cameras should fit the canopy with the included camera mount as well. 
    • If using the Betafpv beta75X and beta65X with the double stack, you'll have to raise the canopy higher to allow for clearance. M2 standoffs will work perfectly. 

    Motor wire extensions available as an add on for betafpv motors, and or motors with shorter leads. 

     Have your stack bound to your radio, before the transplant.

    This version is for 110X motors with the 4 hole mounting patterns. Does NOT support three hole mounting pattern motors.