Talon F7 Fusion 20X20 Flight Controller

5 1
$34.99
Our flagship Flight Controller is here and WOW! Using a dual gyro setup in 90° phase and a F7 processor will have your quad dialed in to the max!
OR
  • DESCRIPTION
  • REVIEWS
  • Our flagship Flight Controller is here and WOW! Using a dual gyro setup in 90° phase and a F7 processor will have your quad dialed in to the max!


    Specs

    1. MCU: STM32F722RET6 216MHz
    2. 2x ICM20602 GYROS 90 deg phase
    3. Built in Betaflight OSD
    4. Up to 8S (36V) direct battery power
    5. Buzzer pads for external buzzer
    6. Built in voltage monitoring resistor
    7. 5V 2A BEC
    8. Dedicated LDO for Gyro, noise free gyro power
    9. Dedicated LDO for OSD, cleaner OSD signal
    10. Led strip shares 5V with 5V/2A BEC
    11. 6 UARTS: UART1, UART2, UART3, UART4, UART5, UART6
    12. Built in camera control pin with resistor and capacitor
    13. 5 Full UARTS with RX AND TX pins
    14. Logical pin layout for cleanest build possible
    15. 8 pin 4 IN 1 ESC plug
    16. Remapable LED pad for additional motor output
    17. TX3, RX3 can be used for I2C for external compass
    18. 5V, VBAT selectable VTX and CAM power
    19. 16M Blackbox flash chip
    20. No flicker VTX pit mode switch (positive switch)
    21. M4 Can be selected either led_strip signal or M4 signal for RPM filtering

    20 X 20 mounting hole with true 25mm board dimensions

    To get Motor 4 to work please use the CLI command below using Betaflight V4.0.4. A custom hex is coming soon for 4.0.4.

    Resource MOTOR 6 None

    Resource MOTOR 4 C08

    Save


    To get 5V to your VTX please go to the mode tab in Betaflight and setup a mode switch for vtx_pit


    Setting up Pit Mode:




    TOP LAYOUT


    BOTTOM LAYOUT