Team BlackSheep TBS Podracer AIO

$69.95

The TBS Podracer AIO is a powerful whoop board designed to cater for TBS Pro32 Nano VTX and TBS Crossfire / Tracer Nano RX with direct pin-header installation. The result is a clean, compact and lightweight core for your build.

OR
  • DESCRIPTION
  • REVIEWS
  • TBS partnered with Zeez to make this awesome whoop AIO. Introducing the the TBS Podracer AIO, the board is designed to cater for TBS Pro32 Nano VTX and TBS Crossfire / Tracer Nano RX with direct pin-header installation. The result is a clean, compact and lightweight core for your build..

    The FC is equipped with F4+MPU6000 and the ESC is capable of True 30A current running BLHeli32. This board is versitle enough to run on your cinewhoop, 4/5" racer like the podracer and longrange cruiser like the TBS Aureo. 

    FC SIDE

    • Mounting holes: 25.5×25.5 mm / M2 holes
    • Up to 6S input
    • 5V BEC up to 1.2A continuous
    • STM32F411 MCU (Support BetaFlight, EmuFlight)
    • MPU6000 Gyro/ACC
    • OSD chip Onboard (AT7456E)
    • 2 available UART
    • LC Filter for 5V VTX and Camera
    • Direct solder connection for TBS Nano RX and TBS Unify Pro32 Nano
    • Support programmable LED like WS2812 etc
    • Built-in current sensor

    ESC SIDE

    • Signal support: PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600
    • Input voltage: 2S-6S Lipo
    • Continuous current: 30A
    • Peak current: 35A
    • ESC firmware: BLHELI 32
    • PWM Frequency Range: 24KHz up to 96KHz

    GPS INSTALLATION

    Because of the phyiscal limitations, installing a GPS module to the FC will require a few extra steps to remap the board's resources. 
    Note: The follow steps will disable LED and FC's SmartAudio and use as softserial for GPS.  

    HOW TO:

            1. Flash the board with Target: STM32F411

                          

            2. Download the Config file [HERE]. Then load it the board. 

            3. Wire the GPS as shown 

                          

    INCLUDES

    • 1 x TBS Podracer AIO 
    • 1 x Capacitor 
    • 1 x AWG cables set with shrink tubes
    • 4 x mounting gromets
    • 1 x XT60 (Male)
    • 1 x XT30 (Male)
    • 1 x Pinheaders set for TBS VTX and RX