TomoQuads Whoopee HD V2 Cinematic Nano Quad Frame Kit For RakonHeli Ducts


Availability: Out of stock





    3K Carbon Fiber frame

    No Prop view

    Supports Rakon Heli 40mm propeller guards (not included, purchase separatly)

    Uses knurled aluminum standoffs

    Top or bottom mounted lipo battery

    Tpu camera mount to reduce vibration

    Support  16x16 , 20x20 or the diagonally mounted beta75x or mobula stack 

    25mm stack height to fit most of your components with ease 

    CF are cut along the weave.

    6g. CF  only 10g. with hardware



    1mm 3K carbon fiber bottom plate

    1mm 3K carbon fiber top plate

    Size: 92mm MTM 

    Knurled black aluminum 25mm m2 standoffs

    Flexible TPU 3D printed parts

    Supported FC stack bottom plate : 16x16 , 20x20, 36x36 (needs m2 5mm+- standoffs not included)

    Top plate have a 20x20 hole pattern for mounting the Runcam split mini2  or Caddx Turtle

    Motor hole dimension: 9mm  


    Included in the kit:

    1pc. CF bottom plate

    1pc. CF top plate

    3pc. 25mm M2 Knurled aluminum standoffs and screws

    3D printed camera mount

    3D Printed antenna mount

    3D printed battery strap

    Prop guards are not included and must be purchased separately see link below.


    Recommended parts:


    HGLRC Zeus AIO 20x20 stack or 16x16 stack eg: Super S AIO 

    1103 10,000KV motors or higher 

    40mm Beta75x 4bladed props or similar

    Runcam Split Mini 2 or Caddx Turtle 

    Runcam TX20U VTX or similar

    Any micro receiver RX or your choice

    300~450mah 2S lipo battery

    Select Beta75x Kit if you are going to use the Beta75x guards/frame 

    Select Rakon Kit Style1 or Style2 if you are to use  the Rakon Heli 40mm Prop guards for 1103 motors. 

    Get it here:  Plastic Guards  or Aluminum guards


    Build Notes:

    -Remember that this is not a direct conversion kit for your Beta75x. This frame supports 20x20, 16x16  and 36x36  so you can use a wide variety of stack , use the one you think that would  work best for your build. The recommended build is just a guidline. 

    -Following the recommended build will saves you a lot of headache avoiding  the hassle of sourcing for parts thats can be hard to find.

    -Keep your build as light as possible by using lighter components .Proper cable management is also very important to save on weight.

    -If you are using a 16x16 or whoop fc stack you will need to mount the 20x20 Runcam Split Mini2 or Caddx Turtle on the top plate unless you are building a straight 20x20 stack

    -For Rakon Heli prop guards you can use either the plastic or the recommended aluminum version. Make sure to select the Rakon kit on checkout 


    Note: Pictures shown are for illustration purposes only and some are not  included with the kit, see product description for details. 


    Any Videos?